FK Coilover Suspension Installation

Rear Suspension

Step 11: Chalk front tires, raise rear end of the car, secure on jack stands

Step 12: Remove rear tires

Step 13: Fold rear seats down and un clip plastic panels covering upper shock mounting nut and plate.

Step 14: Remove/Install 17mm upper shock mounting nut and plate. Remove secondary 17mm nut. The shock assembly should drop.

Step 16: I found that the third shaped washer required the center bored to a larger diameter to fit over the threaded portion on the rear shock. Please note that FK supplies two new upper mounting nuts, and two shaped washers to replace those removed earlier.

Courtesy: HappyVdubber